How to Use Torque Multiplier Wrench

You are here: Home » News » Technology Support » How to Use Torque Multiplier Wrench

Instruction:
1. put the sleeve onto the square head of the handle end and the rocking bar on the other end
2. When the sleeve is put on the net to be disassembled or fastened ,pay attention to the direction of lossening an tightening . Roll the rocking bar so that the handle is against the side of another bolt tightly.
3. After the nut is unscrewed ,use the long bar to disassemble quickly.(First use the long bar to screw on quickly and then use labour saving wrench instead during tightening.)

Cautions
1. When tightening nuts, don’t use excessive force.When half-round rebound of the rocking bar is felt. It shows that the nut has come to the place. The overforce is likely to damage the nut or the tools.
2. Do not use this tool as a hammer.
3. Do not add force to the rocking bar by using loop bar or hand bar.
4. Special remander: If a greater force is used but the nut will not be unscrewed,make sure that the direction of the nut and that of the rocking bar are correct.

 

Category: Technology Support | Tag:
Other Items in this category
Sitemap Air Tools Impact Wrench AODD Pump Airbrush Impact Socket Air Riveter
Copyright©2008-2018 www.collwin.com All Rights Reserved.  
Sitemap | Top↑